info@supra-electronics.com
Establishing Bluetooth® connection
To set up a new connection between the earphone and
a Bluetooth® device, the earphone must be switched
on in the connecting mode. Switch earphone on by
depressing multi function button
7
for approx. 8 se-
conds until the control LED
7
flashes blue and red.
The process for setting up a connection can, however,
differ from one Bluetooth® device to the next. Please
also consult the manual of the Bluetooth® device for
further information.
Proceed as follows:
1. The distance between the earphone and the Blue-
tooth® device must not exceed 1 m.
2. Switch earphone on in connection mode (see above).
3. Activate Bluetooth® function using your Bluetooth®
device.
4. Search for Bluetooth® devices within your range
and select “Crane Headphone“ from the list of avai-
lable devices.
5. Where required, enter password “0000“ (not requi-
red for devices using Bluetooth® V2.1 or higher).
6. Select “Yes” if queried whether you wish to connect.
7. Select “Crane Headphone“ from the list of available
devices.
8. Once connection has been established, the blue
control LED
7
of the earphone lights up twice every
4 seconds.
To Next Page
Loading...