www.surebasics.com
Installation
1. Before removing the tape backing cover, test for clearance by placing the lock at
the desired overlapping of doors location to make sure it is not interfering with the
opening of the sliding door or window gap (minimum 7mm gap required).
2. Once position has been determined and tested, clean and dry the surface area.
3. Peel tape backing off, attach as high as possible and close to the place where the
doors overlap. Press down firmly for a few seconds. Leave on for 24 hours for maxi-
mum adhesion before first use.
Check out installation video: surebasics.com/sliding
To Next Page
Need help?
General