Sure Electronics XMTS - User Manual

1
SURE XMTS TEMPERATURE CONTROLLER – SIMILAR TO BELOW
NO
DESCRIPTION
SETTING
1
PV – actual probe temperature
None
2
SV – required temp set point
As required
3
Degrees/current drawn ( not on all models)
-
4
‘OUT’ LED. Power out indicator
-
5
‘AT’ LED. On when in ‘Setup’ mode
6
‘SET’ – function setup button
As required
7
Degrees/Current indicator LED (not on all models)
-
8
‘ALARM’ LED – on when probe open circuit or temp too high/low
-
9
Increase button
-
10
Decrease button
-
11
Power ON/OFF
-
Note!
‘HH’ indicates a thermocouple fault.
‘LL’ indicates thermocouple reversed or short-circuited.
Set PID values to zero for Bit-Type control.
Set LoC to unlocked (value = 0).
Set At to “ON” – so that unit is self-starting.

Sure Electronics XMTS Specifications