To Next PageTo Next Page
Need help?Do you have a question about the SureCall Fusion4Home 3.0 Yagi Panel Kit and is the answer not in the manual?
General| Impedance | 50 Ohms |
|---|---|
| Type | Yagi Panel |
| Beamwidth | 60 degrees |
| Cable Length | 50 ft |
| Compatibility | All US carriers |
| Uplink Frequency Range | 698-716 / 824-849 / 1850-1915 / 1710-1755 MHz |
| Downlink Frequency Range | 728-746 / 869-894 / 1930-1995 MHz |
Identify the outside location with the strongest signal, ideally facing the nearest cell tower and as high as possible.
Assemble and mount the directional Yagi antenna at the highest possible elevation facing the cell tower.
Mount the directional panel antenna on a vertical surface, ensuring separation from the outside antenna.
Connect the AC power cord to the booster and plug into a 110V AC outlet, then turn the power switch on.
Adjust gain dials to maximum unless a band light is red/yellow, then increase separation or reduce gain.
Understand the meaning of solid and flashing LED lights (Yellow, Red) for booster status and operation.
Tips to improve signal coverage, including relocating the antenna, optimizing angle, and increasing separation.
Resolutions for common problems like no power or lack of indoor signal improvement.
Technical details including frequency ranges, gain, supported standards, and power requirements.
Details on the 3-year warranty, including registration and conditions for coverage.
