1
Key Features
l
Complies with IEEE 802.3u 100BASE-TX and
100BASE-FX standards
l
Fiber-optic input supports cable distance up to 2 km
l
Supports ST-type or SC-type fiber optic connector
l
Full-Duplex capable
l
Shielded RJ-45 connectors for twisted-pair port
l
Diagnostic LEDs for easier troubleshooting
l
DTE and HUB connector (RJ-45) support
Package Contents
l One Converter
l One DC adapter
l Four pieces self-adhesive feet
l The Users Guide
Note: Please contact your supplier if any part is missing or damaged
Congratulations on your purchase of the 100M RJ-45 to
Fiber Converter. This Converter supports two RJ-45
connectors for DTE and HUB connections, and pro-
vides a cost-effective solution for 100Mbps Fast Ethernet
twisted pair and fiber optic media. The fiber optic con-
nectivity helps increasing segment lengths of networks
to 2 km, and the flexibility of Ethernet cabling installa-
tions by connecting a 100BASE-TX twisted pair device
to a 100BASE-FX compliant port.
Power
Indicate normal operation.
TX Link
Indicate the unit is receiving link
pulse from TX device.
2
There are five LED indicators on the panel of the 100M
RJ-45 to Fiber Converter for tracking network opera-
tion and diagnosing link problems with the network cable.
SC-Type Fiber ConnectorST-Type Fiber Connector
EP-202FX
EP-202FX-C
Installing the 100M RJ-45 to Fiber Converter incor-
rectly may damage your computer system or the con-
verter itself. Carefully read through this contents before
you install your converter.
RJ-45 connectors
FX Link
Indicate the unit is receiving link pulse from FX device.
TX Activity
Indicate the unit is receiving packets from TX device.
FX Activity
Indicate the unit is receiving packets from FX device.
3
EP-202FX-C: The 100M RJ-45 to Fiber Converter with
SC-type fiber optic connector
EP-202FX: The 100M RJ-45 to Fiber Converter with
ST-type fiber optic connector
Introduction Installation
Front Panel
LED Indicators
Connector Type
To Next Page
Need help?
General