Surefire MINIMUS - Headband Adjustment; Battery Installation and Replacement; Light Operation; Turning On and Adjusting Output

SOS FEATURE
• Depress and hold the push On/Off button for 4 seconds when the Minimus is off or activated.
Depress the On/Off button to turn Off SOS mode.
LIGHT ANGLE ADJUSTMENT
The battery housing can be used to adjust the angle of light up or down 90 degrees (Fig. 5).
TURNING OFF
• Press the On/Off button to turn off the light. (Fig. 4)
• To achieve maximum output rotate knob clockwise in a rapid movement. Likewise to
achieve low level output rotate counterclockwise in a rapid movement.
MAINTENANCE: HEAD PAD CLEANING
1. Remove Breathe-O-Prene pad from back of headlamp.
2. Wash with mild hypoallergenic soap and warm water. Allow Breathe-O-Prene pad to air dry.
3. Re-attach Breathe-O-Prene pad.
HEADBAND CLEANING
1. Remove headband from rear of headlamp assembly.
2. Machine wash with mild hypoallergenic soap and warm water. Allow headband to air dry.
3. Re-attach headband (see earlier instructions).
LED HOUSING AND MOUNT CLEANING
1. To prevent scratching the window, use a soft brush or cotton swab to remove dirt and debris
from the protective window, corners of the LED housing, and around the adjustment knobs.
2. Wipe the LED housing with a clean, damp cloth.
3. Do not use harsh solvents to clean LED housing or optic. They may damage these components.
CONTENTS
• Headlamp assembly
• Headband
• Breathe-O-Prene
®
pad
• One SF123A lithium battery
• One battery end cap
AVAILABLE ACCESSORIES
The following replacement accessories are available from SureFire for the Minimus headlamp:
• Headband
• Breathe-O-Prene pad
• SureFire 123A lithium batteries
• Filter
HEADBAND ADJUSTMENT
1. Move buckle towards back of head to tighten and move buckle towards lamp to loosen. (Fig. 1)
LIGHT OPERATION: TURNING ON
• Press the On/Off button to activate. Rotate the output adjustment dial in either direction to
select one of 13 light output settings. (Fig. 3)
BATTERY INSTALLATION/REPLACEMENT
1. Unscrew battery end cap by turning counter clockwise while holding leash.
2. Insert 123A lithium battery into battery compartment in light housing, positive (+)
terminal first, as shown in Fig. 2. Dispose of depleted battery (if replacing) properly.
3. Turn battery end cap clockwise, until hand tight, while holding leash.
++
REMOVE WASH DRY
WITH MAXVISION HEADLAMP
(Fig. 1)
(Fig. 2)
(Fig. 3)
Adjustment Dial
(Fig. 5)
(Fig. 4)
++
REMOVE WASH DRY
++