Geo-Fence continued...
You need GPS signal to set the Geo-Fence, if you do not have
GPS signal when trying to set the Geo-Fence the alarm will
let you know that it was unsuccessful.
To set the Geo-Fence:
Text Command: Geo1,(distance)
Example 1: To set a Geo-Fence of 500m send the following
text: Geo1,500m
Example 2: To set a Geo-Fence of 2km send the following
text: Geo1,2km
To turn the Geo-Fence off:
Text Command: Geo0
The alarm will text to confirm the Geo-Fence is either set-up
or cancelled.
29
To Next Page
Loading...
