Surewood Cabinets
Compass Manufacturing International / Louisville, KY / www.cmiproduct.com
Lazy Susan Base Corner Cabinet (LSB)- Assembly Instructions
(Includes 30”, 36”, 42” High)
Parts included
2 -Side Panels, 1 Left and 1 Right
2 -Back panels 1 Left and 1 Right
1 -Bottom Panel with attached Spin tray
1 –Shelf with attached spin tray
1 -Top Panel
1 -Diagonal Back Panel
2 -pcs. Face Frame 1 Left 1 Right
2 – pcs toe kick 1 Left 1 Right
1 - Package of Screws & Brackets.
2 – Door Hinges
1. Identify all parts. TIP: We would suggest that 2 people do the assembly of the LSB cabinets.
2. You have 1 (qty) box for your LSB cabinet containing all the parts listed above.
3. Make sure to have clean clear area to work with so the cabinet does not get scratched (carpet, foam, rubber mat). Lay
Face Frame of Cabinet face down on soft smooth protected surface (Diagram A).
4. Slide left side panel into left slot on face frame making sure the pre-cut slots & shelf holes in the panel are facing
towards the inside of the cabinet (Diagram B). TIP: Pre-fit the side panels into the Face Frame and if they seem too
tight lightly sand the edge of the dovetail. TIP: Placing a thin bead of wood glue in the grooves before sliding the
panels in will help with the sturdiness of the cabinets. If the panel is a little too tight to slide freely, use a rubber
mallet and wood block to gently tap into place.
5. Repeat step 4 with the right side panel.
6. Slide bottom panel (with Spin tray attached) into Dado (grooves) in the Frame Face and side panels (Diagram C).
Tools Required Tools Optional
Philips Screwdriver Power Drill/Screw driver
Wood/Rubber Mallet Power Pin gun w/ 5/8” pins
Hard Wood Block Square
Utility Knife
Fine Sandpaper 240 grit
Tape Measure
Small wood chips or toothpicks
To Next Page
Need help?
General