5. Installation
5. Installation
Please make sure that all components listed below are included in your
package.
Qty Description Item No.
1 S 551-P4 / S 551-P6 P560 5100/5101
1 USB cable A553 0130
1 Instruction manual No P/N
1 Calibration certificate
5.1 Installation Requirements
ATTENTION!
Wrong measurement is possible, if the device is not
installed correctly.
• The device is for indoor use only! At an outdoor installation, the
device must be protected from solar radiation and rain.
• It is strongly recommend not to install S 551 permanently in wet
environment as it exists usually right after a compressor outlet.
5.2 Installation Procedure
Because of the casing the S 551 no need a costly installation. Just
connect the sensors like described in the chapter electrical connection.
S 551 9
To Next Page
Loading...
Need help?
General
