Sutron Corporation 8310 & 7310 Users Manual 8800-1125Rev. 2.7 (BETA) 4/16/2014 pg. 124
Switches to the specified language. This effects all speech phrases
that may be spoken (ex: SpeakPhrase and SpeakData). Please note
that any phrases specified in subsequent SpeakPhrase commands
which don’t exist in the specified language will be updated to phrases
that do.
Delay the speech command for the specified number of seconds
(resolution down to milliseconds)
Returns from a subroutine by branching back after the last Call
command. If the Call command wasn’t used, then control passes to
the beginning of the phrase..
Cause all sensors with IsSSPCurData set to “Yes” to have their prefix
phrase, value, suffix phrase and alarm status spoken.
Cause all sensors with IsSSPCurData set to “Yes” to have their prefix
phrase, value, suffix phrase and alarm status spoken.
Speak just the last measured data value of the specified sensor.
Force measurement and speaks just the live data value of the
specified sensor.
Force measurement and speaks the prefix phrase, live value, suffix
phrase and alarm status of the specified sensor.
Speak the last data entered by the user with the InputManual
command (or 0 if no value has been entered).
Speak the specified number.
Example DialInMsg
Label USER-0
SpeakPhrase Hello welcome to the Sutron 8310
Pause 1.0
SpeakPhrase Please press pound
Pause 2.0
BranchNoDTMF USER-0
BranchDTMF
Label DMTF-#
Label USER-1
SpeakPhrase For live data
SpeakPhrase Please press
SpeakPhrase 1
Pause 1.0
SpeakPhrase To acknowledge alarms
SpeakPhrase Please press
SpeakPhrase 2
Pause 1.0
SpeakPhrase To hang up
SpeakPhrase Please press
SpeakPhrase 3
BranchDTMF
Label DTMF-1
SpeakAllTags
BRANCH DTMF
will go to the
DTMF number
pressed.
DTMF 1 speaks tags and DTMF 2
Acknowledges alarms, speaks
alarms and then returns to the
top menu (with BRANCH USER-
0), DTMF 3 will hang-up the
phone.
This introduction is
repeated over and over
(for up to 60 sec) until the
user presses the “#”
button on the phone.
To Next Page
Loading...
