Sutron 8310 - Page 232

Sutron Corporation 8310 & 7310 Users Manual 8800-1125Rev. 2.7 (BETA) 4/16/2014 pg. 232
Command
Description
Access Level
IPCONFIG [/ALL]
Displays the ethernet configuration information that
has been assigned by a connected router via the
DHCP protocol including the IP address assigned to
the 8310. The /ALL option includes more detailed
information including the physical address (ie MAC
ID) and DHCP lease times.
Setup
LANAUTO
Turns Ethernet Power on when connected
Setup
LANOFF
Turns OFF the Ethernet (Local Area Network)
interface
Setup
LANON
Turns ON the Ethernet (Local Area Network)
interface. DHCP is used to locate the gateway,
retrieve the IP address and other internet settings.
Use the IpConfig command to view the current
settings.
Also related: Release, Renew.
Setup
LIST
Displays formatted setup
Setup
LOGOUT
Logout (also quit or exit)
Setup&Data
MAIL [port to msg]
Reads or sends mail message
Setup
MD dir
Make a directory
Setup
MEASURE […]
Measure works exactly the same as the SHOW
command except it causes a live-reading of the
sensor and/or tag values to be taken before the
results are displayed.
Setup
MEM
Display memory usage
Setup&Data
PASSTHRU
port:parity,bits,stop [/HW]
[/ECHO] [/BREAK]
[/CONTROL]
Opens the specified COM port (either unopened or
under the control of remote). Any characters typed
are sent to the port. Any characters received are
displayed. Terminate with by pressing ESC three
times in a row.
The /HW option enables RTS/CTS h/w handshaking.
The /ECHO option causes the characters you type to
be echoed back which can be useful when
communicating with half-duplex devices.
The /BREAK option will send a 500ms break to the
serial port after connecting. This may be used to
wakeup sensors which require a break.
The /CONTROL option (added in version 3.4) allows
the DTR control line to be passed through. This used
to be the default behaviour, but as of 3.4 dropping
DTR or disconnecting will cause a logout to occur.
As of version 3.4, the normal user inactivity timeout
will be applied to passthru sessions; previously a
passthru session would not timeout.
Note: If using passthru to access a port already under
control of Remote, then the existing port settings are
always used. This includes hardware handshaking. If
you try to communicate with a port with hardware
handshaking enabled, and CTS is low preventing
transmission, then the message [CTS LOW] is
displayed.
Setup