Sutron 8310 - Page 233

Sutron Corporation 8310 & 7310 Users Manual 8800-1125Rev. 2.7 (BETA) 4/16/2014 pg. 233
Command
Description
Access Level
RD dir
Remove a directory
Setup
REBOOT
Reboots the 8310
Setup
RECORDING [on|off]
The RECORDING command will display the current
recording status. If “on” is specified then recording is
turned on, likewise “off” will turn recording off.
Setup (when
turning
on/off)
Data (when
viewing state)
RELEASE [adapter]
Releases DHCP leases on network adapters or the
specific adapter if specified. The adapter index can
be retrieved and the current lease viewed with the
“IPCONFIG /ALL” command. DHCP leases are usually
managed automatically, but this command can be
used to verify that a connected router is assigning IP
addresses reliably.
Setup
REN old new
Rename a file
Setup
RENEW [adapter]
Renews DHCP leases on network adapters or the
specific adapter if specified. The adapter index can
be retrieved and the current lease viewed with the
“IPCONFIG /ALL” command. DHCP leases are usually
managed automatically, but this command can be
used to verify that a connected router is assigning IP
addresses reliably..
Setup
REPORT mode
Set status reporting to on, off, none, ssp[0-9], low,
medium, high, i2c, all, debug. (more below)
Setup&Data
SET tag[:value] data
Sets the current value of a tag or setup property to
the specified data. For tags with multiple possible
values, the value number may be specified (1-n). If
the tag contains spaces it may be contained in
double quotes. Data may be an integer, a floating
point number, or a double-quoted string. Setup
properties that contain strings, intervals, or times
should always be specified with double quotes.
Setup