37
4. Warm up the engine for about 5 minutes.
REMOTE CONTROL MODEL
1. Squeeze the fuel line priming bulb several
times until you feel resistance.
2. Make sure that the warm-up lever is in the
fully closed position.
NOTICE
Continuing to operate your outboard motor
with the Caution System activated could
result in severe damage to your outboard
motor.
If the caution lamp remains lit after starting
the engine, check the engine oil level and add
oil if necessary. If the oil level is correct, con-
sult your authorized Suzuki marine dealer.
NOTICE
Operating the engine at high RPM or “wide
open throttle” immediately after starting the
engine without allowing the engine to warm
up may cause engine failure.
Always allow the engine to warm up suffi-
ciently before operating it at high speeds.
3. Turn the ignition key to the “ON” position.
4. Turn the ignition key to the “START” position.
NOTE:
If the engine fails to start after 5 seconds, wait
10 seconds and try again.
NOTICE
If you turn the ignition key to the “START”
position for more than 5 seconds, the starter
system could be damaged.
Never turn the ignition key to the “START”
position for more than 5 seconds.
NOTICE
If you turn the ignition key to the “START”
position while the engine is running, the
starter system could be damaged.
Never turn the ignition key to the “START”
position while the engine is running.
NOTICE
If the Caution System is not working properly,
you may not be alerted to a condition that can
cause damage to your outboard motor.
If the caution lamp does not come on or the
buzzer does not sound when the ignition key
is turned on, the caution lamp or buzzer may
be broken or a failure may exist in the system
circuit. Consult your authorized Suzuki
marine dealer.
To Next Page
Loading...
