2-124
BEFORE DRIVING
52RM0-01E
Transaxle warning light
(if equipped)
80J219
When the ignition switch is turned to “ON”
position or the engine switch is pressed to
change the ignition mode to “ON”, this light
comes on for several seconds so you can
check that the light is working.
If this light comes on when the engine is
running, there is a problem with the auto-
matic transaxle system. Ask an authorized
SUZUKI dealer to have the system
inspected.
(For CVT models)
If the CVT fluid temperature becomes too
high, this light will blink. Stop the vehicle in
a safe place and let the fluid cool down.
Immobilizer/keyless push start sys-
tem warning light
80JM122
When the ignition switch is turned to “ON”
position or the engine switch is pressed to
change the ignition mode to “ON”, this light
comes on briefly so you can check that the
light is working. If this light stays on, there
is a problem with the system or the steer-
ing lock cannot be released. If this hap-
pens, press the engine switch, turning the
steering wheel to the right or left. If this
light still stays on, ask an authorized
SUZUKI dealer to have the system
inspected.
Open door warning light
54G391
This light remains on until all doors (includ-
ing the tailgate) are completely closed.
If any door (including the tailgate) is open
when the vehicle is moving, a ding sounds
to remind you to close all doors completely.
Low fuel warning light
54G343
If this light comes on, refuel the fuel tank
as soon as possible.
NOTICE
Continuing to drive the vehicle when
the malfunction indicator light is on
or blinking can cause permanent
damage to the vehicle’s emission
control system, and can affect fuel
economy and driveability.
To Next Page
Loading...
Need help?
General
