2-69
BEFORE DRIVING
52RM0-01E
Oil indicator
If either of odometer reading or time is
reached to the value which is set by the oil
life monitoring system, the oil change
request light comes on when the ignition
switch is in “ON” position. The “OIL” indica-
tion is shown on the information display (D)
to tell you it is necessary to change the
engine oil and oil filter.
52RM20510
For instructions on how to change the
engine oil and filter, refer to “Changing
engine oil and filter” in “INSPECTION AND
MAINTENANCE” section or consult an
authorized SUZUKI dealer for advice on
appropriate procedure of engine oil and oil
filter maintenance.
To figure out the next oil and oil filter
change timing properly, it is necessary to
reset the odometer display and the time for
the light. The light will go out after the
reset. For the resetting procedure, it is rec-
ommended to consult an authorized
SUZUKI dealer. If you reset it by yourself,
follow the procedure described below:
1) Turn the ignition key to “ON” position.
2) Push and hold the indicator selector
knob (2) until the “OIL” indication fin-
ishes blinking when the display shows
the oil change request light and oil indi-
cator.
52RM20520
3) While pushing and holding the indicator
selector knob (2), the display will
change as follows. When the oil life
monitoring system is reset, the oil
change request light and oil indicator
will go out and then the display indi-
cates odometer.
52RM20670
Fuel gauge
The display (E) shows the fuel gauge.
Refer to “Fuel gauge” in this section.
To Next Page
Loading...
Need help?
General
