What to do if my Svan Cooktop smells like gas?
If you smell gas, stop using the cooktop immediately and close the middle valve. Open a window to ventilate the area and contact our service center using a phone from outside.
Why is my Svan SGW3600X Cooktop not ignited?
Your Svan Cooktop might not ignite due to several reasons. First, check the electricity supply. Second, make sure that the burner lid is assembled correctly. Finally, ensure that the gas supply is completely open.
What to do if flame goes out when using Svan SGW3600X Cooktop?
If the flame on your Svan Cooktop goes out during use, it could be due to a few reasons. Check if the flame supervision device is contaminated and clean it. If you were cooking something that boiled over, it may have extinguished the flame; in that case, turn off the burner knob, wait one minute, and reignite the zone. Also, a strong draught might have blown the flame out; turn off the zone and check for draughts, wait one minute, and reignite.
Why is my Svan SGW3600X badly ignited?
If your Svan Cooktop is badly ignited, there might be several reasons: * The gas supply is not completely open, so open the gas supply completely. * The burner lid is badly assembled, so assemble it correctly. * The ignition plug is contaminated with alien substance, so wipe it with a dry cloth. * The burners are wet, so dry the burner lids carefully. * The holes in the flame spreader are clogged, so clean the flame spreader.
Why does my Svan SGW3600X Cooktop have a yellow flame?
A yellow flame on your Svan Cooktop could be because the holes in the flame spreader are clogged, so clean the flame spreader. Alternatively, a different gas might be used, so check the gas being used.
Why is my Svan Cooktop flame unstable?
An unstable flame on your Svan Cooktop could be due to the burner lid being badly assembled. Make sure to assemble the burner lid correctly.
Why does my Svan Cooktop make noise when combusted and ignited?
The noise from your Svan Cooktop during combustion and ignition is likely due to the burner lid being badly assembled. Ensure that the burner lid is correctly assembled.
To Next Page
General