·Installation instructions
When install a Heat pipe Refrigerator, ventilation should be considered seriously, please refer
to the following:
·There should be left at least 200 cm³ for ventilation
·The distance between wall and refrigerator side should be at least 20mm
·The bottom should be left at least 50mm for air flowing air passing through must not be preheated
·The following four pictures show four installation ways:
·Entire cooling system should be considered in the ventilation
·PRODUCT FUNCTION DESCRIPTION
1. It is intended to be used exclusively for the pantry.
2. This refrigerating appliance is not suitable for the freezing foodstuffs.
3. The pantry is recommended to be designed at 17℃.
4. The shelves placed in factory mode is the most efficient use of energy for the refrigerating appliances.
5. The following combination of shelves is recommended for energy to be used as efficiently as possible
by the refrigeration unit.
6. When the surrounding temperature is 25℃ and the pantry has no load, it will take around 3.5 hours
to decrease the pantry ’s temperature from 25℃ to 17℃.
7. The pantry is recommended to be designed at 17℃. The energy consumption is 0.268 kWh/24h. If the
setting temperature is higher than 17℃, the energy consumption will be lower. If the setting temperature
is lower than 17℃, the energy consumption will be higher.
The first shelf
The second shelf
To Next Page
Loading...
