ENG
5
PS-370
User Manual
Connecting an additional speaker
For model PS-370 you can connect an additional speaker (Bluetooth mode only):
• Turn both speakers into Bluetooth mode;
• Make sure both PS-370s are not connected to a signal source via Bluetooth;
• Press and hold button b on both speakers. (Both speakers must be in search mode);
• If two speakers are successfully connected between themselves, there will be a short beep;
• Connect the signal source to the speaker.
TECHNICAL SPECIFICATIONS
Parameter, measurement unit Value
Frequency response, Hz 70 – 20 000
Output power (RMS), W 40 (2 × 20)
Membrane, mm Ø 70
Rated current consumption, A 0.25
Battery capacity, mA * h 3600 (2 pcs)
Power supply USB/
5V
Weight, g 2500
Dimensions, mm 360 × 147 × 190
Notes:
• Technical specifications given in this table are supplemental information and cannot give
occasion to claims.
• Technical specifications and package contents are subject to change without notice due to
the improvement of SVEN production.
Technical support is on www.sven.fi.
To Next Page
Loading...
