•
Before making any connections, make sure that the MSS is unplugged. Then connect
the speakers via the audio cable (see Fig. 2).
• Plug the RCA connectors of the 2RCA to 3.5 mm mini-jack stereo signal cable (included)
into the AUDIO INPUT L/R input, and the 3.5 mm mini-jack of the signal cable – into the output
of your PC sound card or an audio output of another sound source, as shown in Fig. 2.
Note:
• To connect the MSS to a CD/DVD/MP3 player or TV, use the 2RCA to 3.5 mm mini-jack
stereo signal cable (included) with a mini-jack to 2RCA adapter (not included) or a 2RCA to
2RCA stereo signal cable (not included), as shown in Fig. 2.
• Plug the power cord into a mains outlet. Set the master volume level to the minimum by turning
the VOLUME control knob b counterclockwise until it stops.
• Switch on power supply by ON/OFF switch on the active speaker rear panel.
• Select a desired signal source AUX/BT by pressing short button f on the control panel.
“Line input” Mode (AUX)
• Press button f on the side panel to switch the AUX mode. Indicator a on the side panel
will change its light to green.
Bluetooth Mode (BT)
• In order to transmit signal in this mode it is necessary at first to connect the device with a signal
source (see Fig. 2). For this purpose select the Bluetooth mode using button f on the side panel.
Speaker system will enter the search mode, indicator a will blink blue color. .
• It is necessary to select the search mode of devices with Bluetooth on a signal source (tele-
phone, notebook, smartphone, etc.). “SVEN SPS-614/SPS-701/SPS-705” massage will be
displayed on the screen, which is to be connected to*.
• The indicator a lights continuously when connection is successful. If there is no connection,
indicator a will blink. In this case the system should be switched over to the search mode once
again (turn off and turn on Bluetooth mode)**.
• Adjust the volume level by turning the VOLUME control knob b. By turning the knob clockwise,
you increase volume level; by turning the knob counterclockwise, you reduce it.
• Adjust the treble and bass levels by turning the TREBLE control knob c and BASS control knob
d respectively. By turning the knobs clockwise, you increase the treble/bass level; by turning
the knobs counterclockwise, you reduce it.
• Connect your headphones to the headphone jack e (see Fig. 1).
* You might have to enter “0000” code to connect some models of devices via Bluetooth.
** If the item has been already registered in the device list of a source, then the second search mode
activation is not obligatory. Choose only the item name and the “connect” command on the source.
Note:
• After using the MSS, mind to switch it off on the active speaker rear panel by ON/OFF switch,
and unplug the power cord.
17
ENG
Operation Manual
sPS-701
sPS-705
sPS-614
To Next Page
Loading...