Sven SRP-355 - Connection and Operation; Speaker System Battery Charging

ENG
4
Portable Radio
g
q
r
p
s
(rear)
Fig. 1. Speaker system description
CONNECTION AND OPERATION
Attention! The built-in battery must be charged completely prior to the application.
Speaker system battery charging
• Connect the speaker to the 230V mains socket via the jack
n using the power cord
(included) or via the jack
o to the 4.5V battery charger (not included). During battery
charging the indicator
m is red.
• The battery is used in the speaker system as an integral part of the device, therefore
do not try to extract or replace it, because this can result in the warranty cancellation or
the device damage.
Attention! For powering the speaker, it is possible to use D/UM-1 batteries (2
pcs.) (not included). Install them into the battery compartment s. Observe the
polarity.
ON OFF
d
b
a
g
e
f
c
j
h
i
m
k
l
o
n