What to do if Sven Controller stabilizer does not turn on voltage?
If the Sven Controller stabilizer doesn't turn on, first, check if the switch is in the 'on' position. Then, ensure that the mains socket has voltage. Finally, if an excessive load is connected, disconnect part of it and turn on the protective fuse.
Why my Sven Controller is on but the light does not go out 'Delaying/Protection' and there is no output voltage?
If the Sven Controller stabilizer is on, but the 'Delaying/Protection' light doesn't turn off and there's no output voltage, it could be due to a test circuit crash or overheating. In the event of a test circuit crash, try switching the AVR off and on again. If that doesn't work, the device needs professional attention. For overheating, allow the product to cool down.
General| Connectivity | Wired |
|---|---|
| Interface | USB |
| Buttons | 12 |
| D-Pad | Yes |
| Vibration Feedback | Yes |
| Cable Length | 1.8 m |
| Compatibility | PC |
To Next Page
