Swagman Park 6 User Manual

ITEM: 64019
Page 1 of 1
Danik Industries Ltd.
300 - 1880 Government St.
Penticton, B.C. V2A 7J1
Phone (250) 490-8883
Fax (250) 490-8885
www.swagman.net
Park 6
Bike Storage Unit
Rev 16/10/07
Diagram 1
Diagram 2
PARTS LIST
1. End Bars - 2
2. Top and Bottom Tubes
with Holes - 2
3. Stabilizing Bar no Holes - 2
4. Separating Tubes - 9
5. Plastic End Caps - 4
6. Washers - 8
7. Bolts - 8
ASSEMBLY INSTRUCTIONS
1. Lay both #2 poles on the ground.
2. Insert the #4 poles into the holes
of the #2 poles while they remain
on the ground.
3. Applying gentle pressure to keep
the poles in place stand this
section up while leaving the
bottom tube on the ground.
4. Bolt one end bar #1 to the side of
the middle section (see diagram 1).
5. Repeat and bolt second end bar
#1 to back.
6. Line up both stabilizing bars #3 at
front and back of base of rack (see
diagram 1) and bolt on using bolts
#7 and washers #6 provided.
7. Insert plastic end caps #5 into top
and bottom of the end bars #1.
8. Tighten all bolts until rack is snug
and there is no excessive
movement (diagram 2).
9. Store 3 bikes on either side of the
rack for a total of 6 bikes as shown
in diagram 3.
1
2
3
5
6
7
4
2
Diagram 3

Swagman Park 6 Specifications

General

Brand	Swagman
Model	Park 6
Category	Bicycle Accessories
Language	English

Summary

Parts List

Assembly Instructions

Diagram 1

Illustrates the initial steps of assembling the bike rack, showing parts and connections.

Diagram 2

Provides a close-up view of tightening bolts to ensure the rack is secure and stable.

Diagram 3

Shows the final configuration for storing six bicycles on the rack.