Technical Specifications
Video
Video Format: AVI
Resolution: 640 x 480
Video File Size: Approx. 25MB per min
Image
Image Format: JPEG
Resolution: 1280 x 1024
Image File Size: Approx. 150KB
Recording
Recording Mode: Manual Recording, Continuous
Total Storage Time: up to 2.5hrs (4GB) and 1.25hrs (2GB)
General
Operating System: Windows XP, Vista
Internal Memory: 2GB
(SW234-PC2, SW361-PD2) or 4GB (SW234-PCG, SW361-PD4)
Backup Type: USB
Battery Type: Rechargeable Lithium-ion
Charging: USB via computer
Record Time per Charge: Approximately 90mins
Battery Charging Time: Approximately 60 mins
Dimensions: 140mm x 15mm x 12mm
5.5” x 0.59” x 0.47”
Weight: 1.3oz, 37g
Troubleshooting Guide
Problem: The PenCam takes a long time to boot or save recordings
Solution: Clear or back up some or all of the files from the PenCam. The more storage used up in
the PenCam the longer it may take to boot or process saved files.
Problem: Some of my videos won’t play on my computer.
Solution: Videos can become corrupt and will not play if the PenCam is not used as described in this
manual. Pushing the button several times or holding the button can result in corrupt videos. Wait until
the PenCam has finished processing before pressing the button again.
Problem: Is it legal to record people in my country?
Solution: It is your responsibility to research the local laws and conditions of use for recordings.
Problem: I can’t see any video on my computer.
Solution: Install the codec pack stored on the PenCam or from our website www.swannsecurity.com
Problem: My PenCam will not record.
Solution: Make sure the PenCam is not plugged into a USB port. Make sure the PenCam is charged.
Problem: I cannot turn my PenCam off or it is not responding.
Solution: Make sure the PenCam is not recording. If the Blue light is on, push the button once, when
the light changes to orange, press and hold until the orange light turns off. If you are still unable to
turn off the PenCam, push the reset button.
Problem: I cannot view images from the PenCam.
Solution: Image files can become corrupted if the button is constantly pressed before the images
have been processed. Make sure you wait until the Blue light changes to Orange before pressing the
button again to take the next image.
To Next Page
