300AF
Page: 3 of 17
Toll Free:
1-800-888-1352
SAFETY
01 Scope
This manual covers all information and requirements to operate the
SWEED Chopper 300AF
02 Standards / Environment
02.A Electrical Machine is built in accordance with all N.E.C and local requirements.
02.B Mechanical
Machine/System is design and tested before shipment at SWEED’s
Facility to ensure correct machine tolerance and electrical integration
and operation.
02.C
Machine
Location
Designed to be mounted/bolted to sturdy stand and not welded. Must
be placed on level surface protected from elements. Machine to only be
lifted using lifting eye located on top of machine. Machine is easily
portable on a stand with casters; however, the machine should never be
moved if it is powered on, or in motion.
02.D
Machine
Clearances
Suitable clearance must be present around all sides of machine. Install
machine at ergonomically suitable infeed height. All controls should be
between 36” and 72” high.
02.E Defects
Machine will be free from defects; small paint
present prior to receiving from testing machine at facility.
02.F
Weather
Exposure
No Rain; No Direct Sunlight on UV sensitive rubber
components or synthetic components.
02.G Welding
Do not weld to machine or add components to machine of any
kind; may result in voiding warranty. Could damage machine
or result in bodily injury.
02.H
Bump
Rotation
When wiring the chopper, check polarity to verify rotation prior to
running a full cycle. Do this by quickly starting and stopping the
machine to visually ensure the rotation is correct.
See figures 9a & b
for
correct direction of rotation.
03
Operating Personnel
03.A Requirements
Trained operators and maintenance technicians who have read and
understand manual only.
03.B
Req.
Clearance
Operators should stay in safe zones outline by company standards and
guidelines (if applicable).
03.C
Warning
Labels
See
Figure
below for all labels used on SWEED equipment; familiarize
yourself with them and their meanings before operation.
To Next Page
Loading...
