Need help?Do you have a question about the swepac FB 510 and is the answer not in the manual?
Provides essential safety guidelines for operating the machine.
Details noise emission levels according to EN 500-4 and Directive 2000/14/EC.
Specifies vibration acceleration and maximum daily exposure time.
Confirms compliance with US-EPA stage 2 requirements.
Illustrates and explains important warning symbols on the machine.
Details the information provided on the machine's identification plates.
Lists key technical specifications for each machine model.
Explains the hydraulic drive system and vibration mechanism for FB 450/510.
Describes the V-belt drive and centrifugal clutch for FB 430/500.
Provides guidance on suitable fuels, engine oil, and hydraulic oil.
Identifies and lists components visible from the left side of the machine.
Identifies and lists components visible from the right side of the machine.
Details daily procedures for checking fuel and engine oil levels.
Explains daily checks for oil/fuel leaks and weekly air filter inspection.
Procedure for checking hydraulic oil level and cooler for FB450/FB510 and FB430/FB500.
Guidance on checking V-belt tension, condition, and vibration element for leaks.
Detailed procedures for starting and stopping the FB450 and FB430 models.
Detailed procedures for starting and stopping the FB510 and FB500 models.
Details on machine operation, movement control, and handling.
Guidelines for safe lifting, securing, and locking the machine for transport.
Information on the electrically heated handle feature.
Details on the SCI sensor, display, and its working principle.
Explains SCI LED behavior during startup and operation based on compaction.
General| Brand | swepac |
|---|---|
| Model | FB 510 |
| Category | Power Tool |
| Language | English |
To Next Page
