Fitted Equipment
76
SAS210 MOBILE ALARM SYSTEM
Using the latest microprocessor technology
the SAS210 provides all year round
protection for your caravan.
Please read all sections of these user
instructions before attempting to operate the
SAS210.
If you are unsure of any of the following
points, please contact your local dealer or
the manufacturer direct (see point 5), on
page 77
1. Operation
Arm/Disarm
The SAS210 Alarm System is armed and
disarmed by pressing the button on the key
fob remote controller.
The alarm has four modes of operation:
a) Disarmed
b) Fully armed with internal movement
sensor and tilt sensor active
c) Partially set with only the tilt sensor active
d) Partially set with only the movement
sensor active.
The alarm indicates arm/disarm status by
beeping. One beep = armed, two beeps in
quick succession = disarmed.
To part set the alarm (modes c or d) hold
down the arm button until the desired mode
has been selected:
Hold down and release after 2 long beeps,
mode (c) selected.
Hold down and release after 3 long beeps,
mode (d) selected.
Note: if the arm button is continually held
down the system will disarm and then repeat
the above sequence.
PIR Movement Sensor
The SAS210 Alarm System comes complete
with a 120° x 360° Passive Infra Red
movement sensor that detects body
movement within the vehicle.
If you are leaving pets within the vehicle the
system should be armed in mode (c) to
prevent nuisance triggering.
Tilt Sensor
The SAS210 Alarm System has an inbuilt tilt
sensor that detects tilting of the vehicle
during the hitching process. If the tilt sensor
is not set correctly, the alarm will not arm
and will indicate a fault by beeping 4 times in
rapid succession.
During normal (on the flat) operation there is
no need to alter the tilt sensor.
If the vehicle is parked on a steep slope it
may be necessary to adjust the tilt sensor.
With the alarm disarmed, while viewing the
movement sensor lens, move the tilt
adjustment lever forward until the green light
illuminates. Note the position of the lever.
Now move the lever backwards and again
note the position of the lever when the green
light illuminates.
Set the lever mid way between the two
positions.
Remember to return the lever to the centre
(locked) position when returning to 'on the
flat' use.
Alarm Siren
When the alarm is triggered the siren will
sound for 2 minutes. Following the 2 minute
period the alarm will then deactivate for 15
seconds then rearm.
The alarm siren can be turned off at any
point by pressing the key fob button. If the
movement sensor caused the alarm trigger,
the alarm will give a standard 'two beeps in
quick succession' disarm indication. If the tilt
sensor caused the alarm trigger, the alarm
will give 'two beeps in quick succession'
followed by a further 'two beeps in quick
succession'.
Sleep mode
The SAS210 Alarm System incorporates a
sleep mode that extends battery life over a
long period of time.
To Next Page
Loading...
