EasyManua.ls Logo

Swift Group Elegance - Page 74

Swift Group Elegance
192 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Fitted Equipment
77
If a charged leisure battery is fitted and is
supplying 12V to the alarm system the alarm
will operate in standard 'quick response'
mode.
If the alarm is operating from the internal
alarm battery only, the alarm will operate in
'slow response' battery saving sleep mode.
In this mode you will need to press and hold
the arm/disarm button for up to 3 seconds
to arm or disarm the alarm.
2. Key Fobs
The SAS210 Alarm System comes complete
with 2 key fob remote controllers. If an
additional controller is required these can be
ordered from your supplier.
Key Fob Battery Replacement
1. Remove the key fob from your key ring.
2. Prise the casing apart near the key ring
fixing slot.
3. While holding the base part of the casing,
prise out the old Lithium battery and
replace with a new CR2032 battery.
Ensure the [+] terminal is located towards
the outer case.
4. Relocate the two casing halves and snap
together.
5. Refit the key fob onto your key ring.
6. Remember to dispose of old batteries in
accordance with local regulations.
3. Battery
The SAS210 Alarm System incorporates a
3.3Ah sealed lead acid battery that is
charged from the vehicles 12V supply. This
battery has been selected to run the alarm
without any external supply voltage for up to
9 months depending on ambient
temperature/initial charge.
The battery is fully charged when the alarm
system is despatched, but may need further
charging if the vehicle is stood for a number
of months without a 12V supply to the alarm.
To charge the alarm battery either fit a fully
charged leisure battery to the vehicle or
connect the vehicle to the mains supply and
switch on the 12V charger/power supply.
The internal battery should be replaced
approximately every 3 years to ensure
correct operation. Replacement batteries can
be ordered from your supplier. Always
dispose of old batteries in accordance with
local regulations.
4. Specification
Control Box
Supply voltage: 10.5 to 15V DC
Supply current: 250mA max
Operating temperature: -5 to +30°C
Battery capacity: 3.3Ah at 12V
Operating time (armed)
with no supply: 9 months at 20°C
Siren output: 110 dB +/- 10%
Movement Sensor
Range: 120° x 360° x 8M
Current consumption: <1mA typical
Key Fob
Range: >10M typical
Battery: CR2032
Lithium Cell
Typical battery life: 1 year
5. Spare Parts/Service
For spare parts, local supplier contact details
or other service information please contact:
Sargent Electrical Services Ltd.
service desk on 01482 678981
during normal office hours.

Table of Contents

Related product manuals