2. Insert the lower handle into the slot (2).
3. Align the holes on the handlebar and the machine.
Insert the bolts through the holes and tighten up
(3&4).
Assembling the Grass Catcher
1. Insert the two lower parts together until it clicks (1).
2. Turn in the two screws at the bottom (2).
3. Put on the upper part and press it together until it
clicks. (3).
Attaching the Grass Catcher
1. Lift the discharge flap (1).
2. Hook the grass catcher bag into the lawnmower (2).\
3. Fold the discharge flap down (3).
Adjusting the Cutting Height
The cutting height can be adjusted from 0.98” to 2.95”.
1. Pull the handle outwards slightly.
2. Set the required cutting height.
3. Release the lever again.
Inserting/Replacing the Battery
Ensure that the battery is fully charged before inserting it
into the tool.
1. Open the battery cover (1).
2. Press the charged battery into the power tool until it
clicks into place (2).
3. Close the battery cover (3).
Removing the Battery
1. Press the release button (1).
2. Pull out the battery (2).
GENERAL SAFETY WARNING #4!
CAUTION: Protect the battery contacts when the battery
is not being used. Loose metal parts may short-circuit the
contacts – Explosion and fire hazard!
Switching the Power Tool On
1. Press the switch interlock and hold down (1).
2. Pull back On/Off switch towards the handle (2).
3. The motor runs.
Switching the Power Tool Off
1. Release the On /Off switch (2).
GENERAL SAFETY WARNING #1!
Removing and Emptying the Grass
Catcher
1. If the grass catcher bag is full and should be emptied
immediately.
To Next Page
Need help?
General
