Quick Start Guide version v2014.1 © 2014 Swiftpoint Limited. All rights reserved.
Quick Start Guide
Charging the Mouse
To charge your Swiftpoint GT:
1. Plug the USB charger into a USB port on your computer or into a USB charging
accessory.
2. Dock the mouse onto the charger.
The battery LED will flash while charging and turn o once fully charged. A full charge
can take up to 90 minutes.
To begin using the mouse, move the switch on the underside to the ON position.
Connecting the Mouse Via USB Receiver
To connect via the USB charger/receiver, plug the USB charger/receiver into a port on
your computer and move the switch on the underside of the mouse from the OFF to the
ON position. The mouse will automatically connect to your computer.
Connecting the Mouse Via Bluetooth 4.0
Once the mouse is fully charged, you can pair it to your computer via Bluetooth 4.0.
Remove the USB charger/receiver. Leave the mouse OFF for the first steps.
For Windows 8 or 8.1
1. Bring up the Charms menu by moving the pointer to the bottom right corner.
2. Select Settings, then Change PC Settings.
3. Then:
Windows 8
Select Devices, then Add a Device.
Windows 8.1
Select PC & Devices, then Bluetooth
from the column on the left.
4. Remove any existing “Swiftpoint GT” in the list by selecting it, then selecting
Remove.
5. While holding down either mouse button, move the switch on the underside of the
mouse to ON. The LED will flash to indicate pairing mode.
6. When “Swiftpoint GT” appears in the list of searched devices, click on the device
name to install and pair with the device.
For Other Devices
Make sure your computer or device is ready to pair. Next, put the Swiftpoint GT into
pairing mode. To do this, hold down either mouse button, then move the switch on the
underside of the mouse from OFF to ON. The LED will flash to indicate pairing mode.
USB charger/
receiver
OFF
CONFIG
ON
Stylus
Scroll wheel
Docking
point
Switch
Left-click
Right-click
Tilt mouse upward
to engage stylus
Thumb grip
LED
Middle finger
grip (hidden)
If you connect your Swiftpoint GT
via Bluetooth, you can plug the USB
charger/receiver into a USB charging
accessory rather than using one of your
computer’s USB ports.
To Next Page
Need help?
General
