Why is the pressure too low in my Swim & Fun Filterballs System 100W?
If the pressure is too low in your Swim & Fun Water Filtration System, it's likely that the pump or hoses are blocked with debris. To resolve this, clear any dirt from the inside of the top valve and inspect the hoses for impurities like leaves.
How to troubleshoot a Swim & Fun Filterballs System 100W pump that runs but pumps no water at startup?
If your Swim & Fun Water Filtration System pump runs but pumps no water at startup, it's likely due to air in the system or the pump not being at the correct level. Ensure the pump is positioned lower than the pool bottom to allow natural water flow. Also, prime the hoses; refer to paragraph 6 for the priming procedure.
Manual and robotic pool cleaners for efficient pool maintenance.
Various pool covers for dirt prevention, temperature maintenance, and security.
Superior filtering media for clear pool water, easy to handle.
Protection for pool, liner, and skimmer against winter frost.
Crucial safety precautions and warnings for product operation and user safety.
Information on warranty coverage, exclusions, and claim procedures.
Identification of all components included in the product package.
Step-by-step guide for assembling the filter system components.
Helpful tips for priming and operating the filter system.
Information on water care products and cleaning the pool bottom and waterline.
General| Power | 100W |
|---|---|
| Category | Water Filtration Systems |
| Product Name | Swim & Fun Filterballs System 100W |
| Type | Filterballs System |
| Suitable for pool volume | 30, 000 liters |
| Pump capacity | 4, 500 liters/hour |
| Filter media | Filterballs |
To Next Page
