Swim & Fun PRO CLASSIC basic - Trouble Shooting

SANDFILTERSYSTEM PRO CLASSIC basic (DK,SE,UK,FI,NO,PL)
26
Swim & Fun Scandinavia ApS – info@swim-fun.com – www.swim-fun.com
10. Trouble shooting
Problem
Cause
Solution
At start the pump is running but not
pumping water into the pool.
Air trapped inside suction hose.
Pump is not placed under the
waterline of the pool
No water passage through hoses?
The pump must be
located at
ground level below the water
line!
Prime the hoses. (See procedure
pkt. 4)
The pressure gauge shows a
pressure exceeding 1.0 bar
Dirty filter sand
Carry out a backwash of the filter
sand
Pressure is to low
Suction hose/skimmer
basket/pump or filter to valve can
be blocked by leaves or debris
Clean suction hose/pool skimmer
and top valve. Check feeding hose
connections for air.
Water escapes from backwash
valve.
The gasket around the 7
-
way
valve is dirty and leaky. Grit in the
gasket.
The
7
-
way valve should be
removed from the filter lid, the
gasket should be cleaned.
Leaking filter connection
(between filter and top valve)
Damaged gasket or sand
Inspect the gasket and replace
with a new one if necessary.
The pump is not running
The f
ilter system has been
deactivated by the filter timer or
a filter control.
The plug is not connected.
The HFI device turns the pump
off.
Damaged pump motor.
Examine the settings.
Connect the plug.
Turn on the HFI device again. If it
immediately turns itself off again
this means that the pump or the
HFI device is damaged.
Replace the pump.
Sand i
n the pool
If the filter sand is new, there
may be small grains which are
washed out or the filter tank.
Carry out repeated backwash
until the backwash return water
is totally clear.
Repairs of the sand filter and pump may only be performed by a qualified, professional firm. Otherwise, the
warranty will be void.