35
Hr - An internal hardware error has been detected
Prr - The Prr error message indicates a problem with the regulation probe. The system is constantly verifying if the tem
perature probe reading is within its normal limits.
HL - The water temperature at the heater has reached 119
o
F (48
o
C). Do not enter spa water.
FLO - The system did not detect any water flow while the filtration pump was running.
UPL - No low level configuration software has been downloaded into the system.
AOH - The temperature inside the spa skirt is too high, causing the internal temperature in the spa pack to increase
above the normal limits.
OH - The water temperature in the spa has reached 108
o
F (42
o
C). Do not enter spa water.
TOPSIDE PANEL DISPLAY MESSAGES
STANDBY MODE
A press of the SETTINGS key brings you into the menu options. Use the UP and DOWN arrow
keys to highlight STANDBY. Press the LIGHT key and the following message will appear.
“All pumps off! Press Drain to drain spa”
This mode allows you to stop all outputs including all automatic functions such as a filter cycle, heating
requests and smart winter mode purging for 30 minutes to perform quick spa maintenance.
DRAIN MODE
If you wish to put your spa into “DRAIN MODE” press the FUNCTION key beside the word “Drain” on
the display. Once you do that the display will indicate “Drain in progress”. The filtration pump will turn on
and run for 60 minutes.
In order to exit this mode, press the FUNCTION key beside the back arrow once to exit DRAIN MODE.
This will put you back into STANDBY MODE and if you wish to exit that press the same key to go back
to the main screen.
To Next Page
Loading...
