!WARNING!
Item can swim into deep water.
Always keep children in sight within
quick and easy reach when they are
in the water. Do not allow children
to play where water is too deep
for their swimming ability.
ASSEMBLY &
INSTALLING BATTERIES
SIDE FIN ASSEMBLY
Insert side fin of RC Cyborg Shark onto
supporting rod as shown. Using a mini
screwdriver, screw fin into place until secure.
New NiMH battery pack is not charged before
shipping. Charge for 12 hours before 1st use.
Note: Any batteries purchased for use in this toy
may pose a hazard to children. Please check safety
notice supplied with batteries before use.
Warning: Dispose of batteries promptly and
properly; do not bury or burn them.
Cautions:
• Batteries to be installed by adults only.
• Use only fresh batteries of the required size
and recommended type.
• Do not mix old and new batteries, different
types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.
• After each use, remove all batteries from the
product, and drain any water that has
accumulated inside. Moisture allowed to
remain inside the product will damage the
electronic components and batteries. Store
the product with the battery compartment
door open to allow it to dry completely.
• Change batteries in dry area.
Your Shark needs these batteries for power,
for best performance and longest life.
• One 9V battery for the transmitter.
• Four AA batteries for the Shark or
rechargeable NiMH battery
HOW TO CHANGE BATTERIES
RC CYBORK SHARK CONTROLLER
1. To open, use Phillips screwdriver to loosen
the 4 screws on the battery compartment
cover and lift the cover to remove it.
2. Put one 9V battery in the compartment.
Make sure that (+) and (-) poles are
positioned properly.
3. Replace the battery cover and secure it
with the screws.
Note: When the transmitter’s range decreases,
replace its battery.
RC CYBORG SHARK
1. When installing new batteries, make sure
that the power is in the off position on the
Cyborg Shark. Turn power off by pressing
the button under the nose of the Shark.
The eyes of the Shark will light up if the
power is still on.
2. To open, use phillips screwdriver to loosen
3 screws on the battery compartment
cover and lift the cover to remove it.
3. Take out the battery compartment box from
the battery compartment.
4. Place 4-AA batteries or 6.0V rechargeable
battery into the battery box.
5. Depending on which battery source you
are using: plug either the AA battery box
connector or the 6.0V rechargeable battery
connector into the Cyborg Shark
connector.
6. Make sure battery and connector are
securely in battery compartment.
7. Replace cover and secure with screws.
Your Cyborg Shark can dive underneath the water for
up to 10 feet and has full directional steering functions.
It has a range of 100 feet.
Transmitter uses:
1 – 9V size battery (not included)
Shark uses: 4 “AA” size batteries
(not included) or rechargeable
NiMH battery (included with charger)
THIS PRODUCT IS DESIGNED FOR SWIMMING POOLS ONLY
(chlorinated or salt water).
CAUTION: For safety, children playing with this toy should be supervised by
an ADULT, as with any products designed to be used in or around water. To
maintain good Shark performance and control, make sure that your RC
Cyber Shark is operated at depths that do not exceed 10 feet.
Ages 8 and up
RC Cyborg Shark
is available in
Red and Blue
When using 2 Sharks
together, make sure
they are not the
same color to prevent
crossing signals.
To Next Page
Need help?
General