EasyManua.ls Logo

Swingline Inspire Plus - Technical Specifications; Service and Repairs; Cleaning Instructions; Laminating Tips and Best Practices

Swingline Inspire Plus
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Technical Specifications
Swingline
®
Inspire Plus Laminator
Electrical
120VAC 60Hz 2.2A 265W(Watt)
Machine Dimensions
2.56 x 5.91 x 13.78 inches (65 x 150 x 350 mm)
Machine Weight
2.2 lbs. (1.0 kg)
Maximum Pouch Width
9.2 inch (241.3 mm)
Maximum Pouch Thickness
3 mil and 5 mil up to legal size
Maximum Through-put Thickness
0.5 mm
Warm-Up Time
Approximately 4 minutes
Speed
9.8 inches (250 mm) per minute
Cleaning
WARNING: UNPLUG THIS PRODUCT
BEFORE CLEANING THE EXTERIOR.
WIPE EXTERIOR ONLY WITH A
DAMP CLOTH AND DO NOT USE
DETERGENTS OR SOLVENTS.
Regularly feed a cleaning card or sheet of paper
through the laminator to clean the rollers.
Laminating Tips
DO NOT LAMINATE AN EMPTY POUCH.
Never insert the loose end of the pouch
rst into the machine. This could cause the
machine to jam. Always insert the sealed
edge rst.
Before laminating important or unique
documents, always run a test pouch through
the laminator using a similar type document.
Do not attempt to do single sided lamination.
This will destroy the laminator.
As soon as hot lamination is completed,
remove the lamination from the rear of the
machine and place on a cool at surface for
cooling to prevent the pouch from curling.
Do not block the vent slots, this will cause
the laminator to overheat.
Do not cut pouches prior to lamination.
Do not use with a carrier.
Service
Do not attempt to service or repair the pouch
laminator yourself. Unplug the unit and contact
an authorized Swingline
®
service representative
for any required repairs.
4

Related product manuals