Do you have a question about the Swisher ZT2560 and is the answer not in the manual?
Engine | 25 HP Briggs & Stratton |
---|---|
Cutting Width | 60 inches |
Fuel Capacity | 8 gallons |
Deck Type | Fabricated |
Turning Radius | Zero-turn |
Transmission | Hydro Gear |
Deck Material | Steel |
Warranty | 2 years |
Use a remote starter switch to test the solenoid between large terminals.
Apply voltage to the solenoid's primary wire if engine cranked in Test 1.
Apply 12V to ignition switch red wire (terminal B) with controls neutral.
Apply 12V to ignition switch green wire (terminal S) with controls neutral.
Listen for fuel solenoid click, check spark plug, and verify spark.
Verify gas valve, air filter, choke operation, and carburetor condition.
Check seat safety switch plug for proper insertion or defects.
Apply 12 volts to the PTO clutch terminal to check for activation.
Measure voltage at the PTO switch brown wire terminal.
Verify continuity between PTO switch connectors when the switch is ON.
Check gray wire for positive power and green wire for ground connection.
Details wire connections for ignition switch and starter solenoid.
Details wire connections for the PTO switch plug.
Explanation of wire functions for the engine plug connection.
Procedure to test charging system voltage and regulator.
Wire connections and type of the carburetor fuel shut-off solenoid.
Aligning drive controls and linkage for neutral.
Using adjusting bolt to make drive wheels pull equally.
Adjusting linkage for straight mower travel.
Diagram and explanation of the drive control linkage system.
Adjusting the parking brake cable tension.
How the neutral switch prevents engine cranking.
Adjusting spring tension for ease of deck lifting.
Steps to level the mower deck correctly.
Instructions for replacing the belt from engine to deck.
Instructions for replacing the deck's cross belt.
Procedure for installing the blade adapter and torque specs.
List of common replacement part numbers for Swisher Mower Co.