OFF
Centro Business 3.0 (XGS-PON)
How to set up
your router
Installation overview
Swisscom (Switzerland) Ltd.
Postfach
3050 Bern
www.swisscom.ch/kmu
0800 800 800
Swisscom (Switzerland) Ltd.
Enterprise Customers
3050 Bern
www.swisscom.ch/enterprise
0800 800 900
B2C-TSP-UID XGS-PON 09/21 EN
Use the included fibre-optic cable.
Send your old device back to Swisscom free of charge for
recycling. Reset the router to factory settings beforehand.
> Open the Business-Center: https://extranet.swisscom.ch
> EC Dashboard: Choose Agreement
> Choose location
> Centro Business > Pairing > Create Pairing >
> Enter MAC-address >
>
Fibre socket: Usually slot 2, rarely slot 1.
If you have subscribed to fixed network telephony, the service will be activated within 15 minutes and the LED lights up white.
The router can restart multiple times during the installation.
Analogue phone
or fax machine
IP phone or
point-of-sale terminal
Ethernet
Phone
Your internet is now ready.
Connect the Fibre-optic cable to
the router.
3
Connect the fibre-optic cable to
the fibre-optic socket.
4
Connect the power adapter and
switch on the router.
5
Wait for the and LEDs to
light up white permanently.
6
Connect your phones directly to the router.
7
Please refer to the relevant
instructions for setting up other
services and products.
8
Note for for Enterprise Connect customers only:
1
The package includes:
Centro Business 3.0
Power adapter
Fibre-optic cable
Ethernet cable
Make sure the router
is vertical for optimum
WLAN range!
Switch off the current router, but only remove it after
successfully setting up the fibre-optic link.
Remove your old Internet /
telephony installations (if any).
2
To Next Page
Need help?
General