swissflex uni 20 85RF

Questions and Answers

C
Crystal ReyesAug 5, 2025
What to do if swissflex uni 20 85RF control systems suddenly stop moving?
- D
  Darren ParkAug 5, 2025
  If your swissflex Personal Care Products control systems suddenly stop moving, there are several potential causes: 1. The thermoswitch on the transformer may have been triggered. If so, leave the control system in the rest position for 20-30 minutes. 2. There may be no mains supply. If so, restore the mains connection. 3. The supply line might be interrupted. In this case, check the supply line and restore contact.
B
Bryan AyalaAug 10, 2025
What to do if swissflex uni 20 85RF Personal Care Products bridge is not working?
- K
  Kenneth ConwayAug 11, 2025
  If the swissflex Personal Care Products uni 20_85RF/uni 22_85RF bridge[®] is not working, even when switched on and properly connected, try the following: 1. Disconnect the mains supply unit from the mains outlet, wait a minute, and then reconnect it. Check that mains voltage (240V) is present, if necessary. 2. If there is no current, check the fuse. 3. Press the “all motors down” button to reset all adjustments. 4. Check the mains supply, as an irregular power supply can lead to malfunctions.
J
Janice FreemanAug 17, 2025
How to fix a swissflex uni 20 85RF Personal Care Products remote control that is not working?
- J
  jdavisAug 17, 2025
  If the radio remote control for your swissflex Personal Care Products isn't working (and the background light is off), try these steps: * Insert new batteries. * Ensure there are no obstacles between the radio remote control and the motor control.
J
Joshua OlsonAug 22, 2025
What to do if the swissflex uni 20 85RF electric reset function cannot be activated?
- M
  Mark BauerAug 23, 2025
  If the battery-operated electric reset function on your swissflex Personal Care Products cannot be activated, here's what to check: * The block battery/batteries might be flat. Check and replace them if necessary. * The block battery/batteries might not be connected. Connect the block battery/batteries.
P
Pamela JonesAug 29, 2025
How to handle loss of power in sitting position for swissflex Personal Care Products?
- S
  Sheryl KaneAug 29, 2025
  To move the swissflex Personal Care Products bed to a horizontal position during a power outage, connect a battery pack and hold the emergency lowering button down until all sleeping surfaces are horizontal.