Note
• The power cord may be dragged by the robot if hanging on the ground,
causing the Dual Empty Station to move or disconnect from power.
• The indicator light on the Dual Empty Station will stay on when powered,
and turn off when the robot is charging.
• If there is an issue with the Dual Empty Station, the indicator light will turn
red and stay on as a reminder.
• Make sure to place the Dual Empty Station on a level indoor surface, away
from open flames, heat sources, water, narrow spaces, or areas where the
robot may fall.
• Placing the Dual Empty Station on non-hard surfaces (such as carpets, mats,
etc.) poses a risk of tipping over, and the robot may not be able to leave the
Dual Empty Station properly.
• Do not place the Dual Empty Station under direct sunlight or block its
signal emitter area with any objects, as this may prevent the robot from
returning automatically.
• Please maintain the Dual Empty Station according to the maintenance
instructions and avoid using wet cloths or wipes for cleaning.
Preparing Your Robot
Removing the protective foam strips
Installing the Side Brush
4.
Note
When you hear a clicking
sound, it means the Side
Brush has been properly
installed.
Powering on and charging
1. Remove the faceplate as shown in the picture, and turn on the
Power Switch. "I" means powered on, and "O" means powered
off.
O
07
To Next Page
Loading...