EasyManua.ls Logo

SwitchBot S10 - Page 7

SwitchBot S10
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Note:
I . When using the robot for the first time, follow it throughout its whole cleaning route
and watch for potential problems. This will help you identify and resolve minor issues
ensuring a more efficient cleaning process in the future.
If the robot gets stuck under low furniture, you can try the following solutions:
(j) Block the bottom of the furniture;
@ Set a virtual wall in the app to prevent the robot from entering;
@If possible, raise the furniture slightly.
Placing the Auto-empty Station
Place the Auto-empty Station on a hard, level surface (such as
floor or ceramic tile) against a wall, ensuring there is at least 1
meter of space in front and above, and 0.5 meters on both sides
Make sure the location has a good Wi-Fi signal to provide a better
network connection and app user experience.
Plug the Auto-empty Station into an outlet, ensure the indicato
light turns on, and store any excess cable in the Cord Wrap.
0.5 m (1.6 ft.)
0.5 m (1.6 ft.)
1 m (3.3 ft.)
Note:
The power cord may be dragged by the robot if hanging on the ground, causing th
Auto-empty Station to move or disconnect from power.
The indicator light on the Auto-empty Station will stay on when powered, and go o
when the robot is charging.
If there is an issue with the Auto-empty Station, the indicator light will turn red and
stay on as a reminder.
Make sure to place the Auto-empty Station on a level indoor surface, away from ope
flames, heat sources, water, narrow spaces, or areas that may cause the robot to han
in the air.
Placing the Auto-empty Station on non-hard surfaces (such as carpets, mats, etc.)
poses a risk of tipping over, and the robot may not be able to leave the Auto-empty
station properly.
Do not place the Auto-empty Station under direct sunlight or block its signal emitter
area with any objects, as this may prevent the robot from returning automatically.
Please maintain the Auto-empty Station according to the maintenance instructions an
avoid using wet cloths or wipes for cleaning.
Preparing Your Robot
Removing the protective foam strips
07