Operating Instructions
www.snopakebrands.com
Installation
• Make sure the waste basket is securely in place
• Connect the electricity plug to any standard power socket
Operation
The switch on your Sword sh shredder enables you to select one of the followings settings:
• power - will turn the shredder on and o . When switched on the shredder is automatically started by inserting
paper into the feed slot. With the electrical cord plugged in, the slide switch in the power position and the
shredder wastebasket properly in place, the auto LED will light up
• reverse - in the unlikely event of paper jam, the reverse setting can be used to help clear the cutters of paper
that has not passed through properly
• forward - helps clear loose paper that is still on the blades or shredder shaft
Capacity
This Sword sh shredder will shred:
• up to 15 sheets of 80gsm paper per pass, with a max width of 220mm.
• paper clips and small staples
• single credit cards
• single CDs, DVDs
Continuous shredding should not last more than 3 minutes, after which the shredder should be allowed to
cool down for 20 minutes before continuing. If the shredder is used continuously for more than 3 minutes, the
shredder will automatically switch itself o . After an auto power o , put the switch into the o position for 50
minutes before turning the shredder back on.
In case of a minor paper jam:
The automatic paper reverse feature should activate and eject any minor paper jams when they occur. Make sure
to remove the un-shredded paper from the feed opening. The overload/overheat light should go out and normal
shredding can resume. If for some reason the automatic paper reverse does not activate, move the switch into
the reverse position.
In case of a major paper jam:
The shredder will automatically switch itself o . After an auto power o , put the switch into the o position for 50
minutes before turning the shredder back on. Grasp the excess paper from the top and pull it out as you press the
rev button.
Warning
• Do not place ngers too close to the feed slot as serious injury may occur
• Always disconnect the power plug before cleaning a Sword sh shredder
• Repairs must be carried out by a specialist. There are no user-serviceable parts inside a Sword sh shredder
• Keep the waste bin emptied so that the shredder output is not impeded
• Sword sh shredders should only be used within the de ned capacity
• Keep all loose articles of clothing, ties, jewellery, long hair or other loose objects away from opening
• Keep children away from the machine. This shredder is not a toy
• Do not pass soft plastics through the shredder
• Shredders should be oiled on a regular basis and before any period of intensive shredding
• Lubrication should always be done when the shredder is cold. Never add oil to a hot shredder
ENGLISH
To Next Page
Loading...
