Operating Instructions
www.snopakebrands.com
Installation
• Mount your Sword sh shredder head securely on the waste bin
• Connect the electricity plug to any standard power socket
Operation
The switch on your Sword sh shredder enables you to select one of the following settings:
• auto- with this setting the shredder is automatically started by inserting paper into the shred opening
• rev- in the unlikely event of paper jam, the reverse setting can be used to help clear the cutters of paper that has not passed
through properly
• o - this setting turns o all functions of the shredder
Capacity
This Sword sh shredder will shred:
• up to 6 sheets of 80gsm paper per pass, with a max width of 220mm.
• Small staples
• single credit cards
Continuous shredding should not last more than 2 minutes, after which the shredder should be allowed to cool down for 45
minutes before continuing. In the event of a major paper jam, or if the shredder is used continuously for more than 2 minutes,
the shredder will automatically switch itself o . After an auto power o , put the switch into the o position for 45 minutes before
turning the shredder back on.
In case of a minor paper jam:
Grasp the excess paper from the top and pull it out as you press the reverse button.
In case of a major paper jam:
The shredder will automatically switch itself o . After an auto power o , put the switch into the o position for 45 minutes before
turning the shredder back on. Grasp the excess paper from the top and pull it out as you press the reverse button.
Oiling Instructions
• To ensure proper operation and function, periodic oiling of the cutting system is required. Failure to oil your cutting system
could result in reduced sheet capacity performance, excess noise, paper jams and possibly machine failure.
• Oil your cutters every time you empty the bin. (See opposite)
•
Use only oil designed for use in shredders! Never use ammable or aerosol lubricants.
• Lubrication should always be done when the shredder is cold. Never add oil to a hot shredder.
• On no account should any aerosol product be used on or near this machine, as the propellants may be ammable.
Warning
• Do not place ngers too close to the feed slot as serious injury may occur
• Always disconnect the power plug before cleaning a Sword sh shredder
• Repairs must be carried out by a specialist. There are no user-serviceable parts inside a Sword sh shredder. Unauthorised
attempts to service the machine will invalidate the warranty
• Keep the waste bin emptied so that the shredder output is not impeded.
Failure to do so can cause serious damage
• Sword sh shredders should only be used within the de ned capacity
• Keep all loose articles of clothing, ties, jewellery, long hair or other loose objects away from opening
• Keep children away from the machine. This shredder is not a toy
• Do not pass paper clips or soft plastics through the shredder
• Shredders should be oiled on a regular basis and before any period of intensive shredding
• Lubrication should always be done when the shredder is cold. Never add oil to a hot shredder
•
Follow these operating instruction. Damage caused by misuse will not be covered by warranty
6
To Next Page
Loading...
