Swordfish Armoured660 - Page 5

Operating Instructions
www.snopakebrands.com
5
Quick Start Guide
Please read this manual completely before using your laminator as incorrect use
can cause serious damage. Failure to follow the instructions in this manual could
invalidate your warranty!
Position the laminator on a suitable  at surface, within easy reach of a 13Amp socket, ensuring that there is su cient
space behind the machine for the laminations to lay  at.
1
Connect the laminator to the 13Amp socket and press the isolating switch on the back of the machine to the
“on” position. The “power” light will illuminate.
2
Press the red “Hot/Cold/O ” button on the control panel once and the machine will run and start warming up.
Press the red “Hot/Cold/O ” button again and the machine will go into cold lamination mode.
Press the button a third time and the machine will stop working.
3
Set the desired temperature according to the guide printed on the laminator. Note that setting the temperature
too high can cause your pouch to jam!
4
The “ready” light will illuminate after 3-4 minutes, depending on the required temperature. Laminating can now
begin.
5
To get the best results from your laminator and extend its working life, please turn to page 6.
If the lamination is imperfect, adjust the temperature to correct the fault – see page 9.
7
Before turning o the machine, press the red “Hot/Cold/O ” button twice. The “cold” light will illuminate. Allow
the laminator to run for 5 minutes before turning o the power. This will allow the rollers to cool evenly.
8
6
You must use a pouch carrier if you intend to laminate any of the following:
• Multiple items within a single pouch
• Irregular shaped items
• Soft material such as newspaper, tissue, paper and fabrics
• Any item that leaves a border of more than a 3mm around its edges
Pouch carriers are available from your usual pouch supplier.