3. Press the PROG+10 Button (#4) again to store selection. The LCD Display (#6) will advance to “02”.
4. Press the Skip+/Skip- Button(#15)to select the next song to be programmed
and press the PROG. Button to
store selection.
5. For CD/CD-R/CD-RW play,you may repeat steps #2 - #3
to program as many as 20 tracks. If you attempt to
program more than 20 tracks, the LCD Display (#6) will revert to “01” and the old entry will be overwritten by
the current new entry!
6. Press STOP Button (#5) to end programming and return to normal play mode.
7. To check the programmed tracks, press PROG+10 Button (#11) continuous to show all the programmed songs.
The LCD Display (#6) will display the program number first and then followed by the flashing track number.
8. Press PLAY/PAUSE Button (#11) to begin programmed play. The first track in program will appear in the LCD
Display (#6) .
9. To cancel programmed play, press the STOP Button (#5).
10. As long as the unit remains on and the CD Door (#7) is not opened, you can resume programmed play any time
by pressing the PROG+10 Button (#4) and then PLAY/PAUSE Button (#11) in stop condition.
RADIO RECEPTION
1. Set the Band Selector(AM/FM/FM Stereo) (#2) to the "RADIO" position.
2. Set the Band Selector(AM/FM/FM Stereo) (#2) to either "AM", “FM” or “FM Stereo” for the desired radio band.
To receive a weak (noisy) FM station, set the Band Selector to the “FM” position. The reception may be
improved, but the sound will be monaural (MONO).
3. Adjust the Tuning Knob #13) (to obtain the desired radio station.
4. Adjust the Volume Control (#3) to obtain the desired sound level.
5. When you wish to turn off the Radio, set the Band Selector (AM/FM/FM Stereo) (#2) to the "OFF" position.
TIPS FOR GOOD RADIO RECEPTION
1. To insure maximum FM tuner sensitivity, the Telescopic Antenna (#8) should be fully extended and rotated to
obtain the best possible reception. The FM Stereo Indicator will light steadily when a stereo program is being
received.
2. When tuning in AM reception, be sure to place the unit in a vertical position. To insure the maximum AM
sensitivity, try repositioning the unit until the best reception is obtained.
■ AUX IN FUNCTION – Connecting the device with an external audio source
This device has the function of audio input. Please connect the source with audio cable (cable not included ) to
AUX IN slot. The mode will jump to AUX IN automatically.
Note:
At AUX IN mode, all the keys are invalid. You must unplug the Audio cable from AUX IN slot, then the unit could
playback CD normally.
To Next Page
Loading...
