Sylvania Srcvt120-150 - Temperature Unit Switching; Activate Back Light; Work Mode; Programming Mode

3
2. Switching between Celsius (°C) and Fahrenheit (°F)–PresstheMODE
buttonandUPbuttonatthesametimetoswitchthetemperaturedisplay
betweenCelsius(°C)andFahrenheit(°F).
3. Activate the back light–Pressanybuttononthecontrolpaneltoactivate
the blue color back light. The light will automatically turn off if no button is
being pressed again.
4. Work mode – Under this mode the convector will operate under the pre-set
temperature.PresstheMODEbutton,theconvectorisnowenteringtheHOLD
mode.ThenpresstheUPorDOWNbuttontoadjustthepre-settemperature.
Theadjustablerangeofpre-settemperatureis3–40°C.
Under this mode, the programming mode will not be activated and the
convector is working under the pre-set temperature continuously.
5. Programming mode–Thereare4programmablesetting(P1toP4).The
convectorisworkingunderthepresettemperature,timeandcyclingfromP1
toP4everydayoftheweek.
A. PresstheMODEbuttontoentertheHOLDmoderst.
B. PresstheMODEbuttonagaintoentertheprogrammingmode.The
displaywillshow“P1”ashing.
C. PressUPorDOWNbuttontoadjustthepre-settemperature.
D. PresstheMODEbuttonagaintosetthe‘HOUR’ofbypressingtheUPand
DOWN button.
E. PresstheMODEbuttonagaintosetthe“MINUTE”oftimebypressingUP
and DOWN button.
F. PresstheMODEbuttonagainandrepeatthestepsin(C)to(E)tosetthe
temperatureandtimeofP2toP4.
E.g. P1 – Temperature 25°C; time 6:00 AM
P2 – Temperature 20°C; time 8:00 AM
P3 – Temperature 25°C; time 6:00 PM
P4 – Temperature 18°C; time 11:00 PM
 TheconvectorwillworkundertheabovepresettimeandtemperaturefromP1
toP4everyday.
Without pressing any button for 15 seconds, the controls will automatically
save the setting.
6. Override mode – ThismodeallowsyoutotemporaryCHANGEthepreset
temperatureinWORKMODEorPROGRAMMINGMODE.
 PressMODE+DOWNbutton,thedisplaywillash.PressUPorDOWNbutton
to set the override temperature.
 PressMODE+DOWNbuttonorMODEagaintoentertheoverride
temperature.TheconvectorisnowworkingundertheOVERRIDEtemperature.
 IftheOVERRIDEtemperatureissetunderthePROGRAMMINGMODE,the
convectorwillonlyworkatthatOVERRIDEtemperatureunderthecurrent
program(e.g.P1).Whentheprogramautomaticallyproceedtothenext
program(P1>>P2)theOVERRIDEMODEwillbecancelandreturntothe
presettemperatureofcurrentprogram(e.g.P2).
 IfyouwanttocancelOVERRIDEmode,pressMODE+DOWNbuttonandthe
convectorwillreturntoWORKMODEorPROGRAMMINGMODE.
==>
==>