Sylvania SYACP-2000 - WALL MOUNTING INSTRUCTIONS; ELECTRICAL WIRING; OPERATION; Time and Temperature Unit Settings

2
WALL MOUNTING INSTRUCTIONS
1. Release the mounting bracket by pressing the locking brackets on both sides.
2. Use the mounting bracket as a template by holding it against the wall as
illustrated in Fig. 1.
3. Follow the dimensions specified in Fig. 1 and place mounting bracket in the
desired location.
4. Mark the 4 screw holes. Place mounting bracket on the screw markings and
ensure the mounting bracket is perfectly level.
5. Predrill holes and insert 4 wall anchors. Wall anchors are needed for
mountingondrywallorconcretewalls.Ensureyouusetheproperanchors
for your wall type.
6. Replace the mounting bracket and fasten it with screws (minimum 4 screws).
7. Mount the convector to the mounting bracket and engage the 2 locking
brackets at the top. See Fig. 2.
CAUTION – HIGH TEMPERATURE, RISK OF FIRE. KEEP ELECTRICAL
CORDS, DRAPERY, FURNISHINGS AND OTHER COMBUSTIBLES AT LEAST
3 FT (0.9 M) AWAY FROM THE FRONT OF THE HEATER AND AWAY FROM
THE SIDE AND OF HEATER.
WARNING – TO REDUCE RISK OF FIRE, DO NOT STORE OR USE
GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE
VICINITY OF THE HEATER.
Fig. 2
Wall
Wall bracket Convector
ELECTRICAL WIRING
WARNING: THIS CONVECTION HEATER IS TO BE USED ON A 240 VAC
POWER SUPPLY AND GROUNDED OUTLETS.
THERMAL CUT-OFF
PROTECTION
HEATER
LCD
BLACK (L)
WHITE (N)
SENSOR
GREEN/YELLOW (G)
CAUTION: TURN OFF MAIN POWER BEFORE BEGINNING INSTALLATION
TO AVOID ELECTRIC SHOCK.
WARNING: THE HEATER MUST bE INSTALLEd bY A
CERTIFIEd ELECTRICIAN ANd IN ACCORdANCE WITH
ALL LOCAL ANd NATIONAL ELECTRICAL COdES.
1. Connect white colored neutral wire (N).
2. Connect black colored live wire (L).
3. Connect green colored ground wire. All connections using twist on wire
connectors. Put all wires properly into the junction box before replacing the
cover with the provided screw.
OPERATION
Turn the “0/I” switch on the right side of the convector to “I” position. The indicator
light and display will be ON.
1. Time setting–PressMODEbuttonandpressUPandDOWNbuttonsatthe
same time.
A. Press the UP or DOWN button to set the ‘DAY’ from MONDAY (MO) –
TUESDAY(TU)–WEDNESDAY(WE)–THURSDAY(TH)–FRIDAY(FR)–
SATURDAY (SA) – SUNDAY (SU).
B. PressMODEbuttonagain.Thedisplay‘HOUR’willashandthenpress
theUPorDOWNbuttontosetthe‘HOUR’.
C. PressMODEbuttonagain.Thedisplay‘MINUTE’willashandthenpress
theUPorDOWNbuttonagaintosetthe‘MINUTE’.
D. PressMODEbuttonagaintoexitandsavethesetting.
2. Switching between Celsius (°C) and Fahrenheit (°F)–PresstheMODE
button and UP button at the same time to switch the temperature display
between Celsius (°C) and Fahrenheit (°F).