BE SURE POWER IS DISCONNECTED PRIOR TO INSTALLATION!
FOLLOW NATIONAL, STATE, AND LOCAL CODES!
READ THESE INSTRUCTIONS ENTIRELY BEFORE
INSTALLATION!
INSTALLATION INSTRUCTIONS
FOR SYMCOM’S MOTORSAVER
MODEL 460-SP
The Model 460-SP MotorSaver
is a voltage monitor designed to protect
single-phase motors regardless of size. The MotorSaver
is used on 190-
240 (95-120) VAC, 50 to 60 Hz motors to protect from damage caused by low
voltage and high voltage.
CONNECTIONS
1. Mount the MotorSaver
in a convenient location in or near the motor
control panel. If the location is wet or dusty, the MotorSaver
should
be mounted in a NEMA 4 or 12 enclosure. The MotorSaver
can be
mounted to a back panel using two #6 or #8 x 5/8 screws or can be
snapped onto a DIN rail.
2. Connect L1 and L2 on the MotorSaver’s terminal strip to the LINE SIDE
of the motor starter (See Figure 1).
3. Connect the output relay to the circuitry to be controlled. For motor control,
connect the normally open contact in series with the magnetic coil of the
motor starter (See Figure 1). For alarm operation, connect the
normally closed contact in series with the control circuit (See Figure 2).
To Next Page
Need help?
General
