Need help?Do you have a question about the Synargy Smart Comfort Juno and is the answer not in the manual?
Remove shoes, sit, extend footrest, and avoid jewelry or watches for safe operation.
Press the power button, wait 20-30 seconds for the chair to power on, then place arms inside rests.
Chair enters automatic massage mode if no buttons are pressed; read for advanced operation.
Power button turns chair on/off. Pause stops functions until pressed again to resume.
Sets massage time in 5-minute increments up to 30 minutes.
Adjusts roller travel up/down for shoulder-focused movements.
A gentle mode targeting the whole body.
Focuses mainly on lower back, legs, and feet.
Focuses on the entire body.
Focuses on the neck and shoulder areas.
Focuses on the back and waist areas.
Lifts footrest and tilts chair back, focusing on the legs.
Returns chair to upright position or allows fine-tuning.
Moves the chair into a zero gravity horizontal position.
Reclines the chair backwards or allows fine-tuning of position.
Toggles airbag function and adjusts pressure intensity for airbags.
Changes manual modes like kneading, shiatsu, tapping, and knocking.
Adjusts roller speed and width for specific manual modes.
Toggles back massage modes: fixed, short area, entire, upper, or lower back.
Adjusts roller position and controls foot roller on/off and intensity.
Provides specific measurements for the chair in various configurations.
Requires at least 275mm clear space between chair backrest and walls/furniture.
General safety advice, including usage restrictions and precautions.
To Next Page
General