7
Chapter 2: Hardware Setup
3
Load drives in the drive trays.
•
For 3.5” drives:
Place the drive in the drive tray. Then tighten the screws to secure the drive in place.
•
For 2.5” drives:
Place the drive in the blue area (shown below) of the drive tray. Turn the tray upside down
and tighten the screws to secure the drive in place.
4
Insert the loaded drive tray into the empty drive bay.
Note:
Make sure the drive tray is completely inserted. Otherwise, the drive might not be able to function properly.
5
Repeat the steps above to install all prepared drives.
To Next Page