（7）Universal code setup
Press 8 +（0-9）Address code + new code + # + new code again + #
（ code:4-6 random figures） ， When use code unlock: input the code + #
confirmation
（8）Press 9 + 86 all system go to default setting
5. Exit programming code
Press * Exit programming code, Note：all set will be saved by press # in two
seconds, press * exit.
6. User code setup
Press * input code after read the ID card，Press # change card code。Input 4
random figures as the new code
Press # input the new code again, press # again save the code。user card
code can’t unlock without the card together.
7. Operation instruction
（1）Recovery program code: if you forget the programmed code,
please press the reset button (under the battery box) and back to the
very begging and other date will no change.
（2）If you unlock the door by card + code, please type the code
after read the card, and press # to confirm.
（3）if you unlock by the universal code, you need press # after
type the code.
To Next Page
Loading...