SYSTEL SunPower 65 - User Manual

Questions and Answers

T
Teresa AtkinsAug 5, 2025
How to troubleshoot a SYSTEL SunPower 65 Gas Heater when the fan does not start?
- C
  Cheryl LopezAug 5, 2025
  If the SYSTEL Gas Heater fan isn't starting, several factors could be at play. First, ensure that 220Vac is present by checking the electrical installation. A faulty thermostat could also be the culprit; inspect the thermostat and its cable, replacing if necessary. Similarly, a fault in the gas control box might be the cause, so check the control box fuse and replace it if needed. The fan cord or switch could also be defective, so check their voltage and replace them if necessary. Finally, the fan itself might be faulty, necessitating replacement.
G
Gabriel ThompsonAug 20, 2025
Why does the flame keep going out on my SYSTEL SunPower 65?
- M
  Michelle ThorntonAug 20, 2025
  If the flame of your SYSTEL Gas Heater goes out, it could be due to a few reasons. The ionization electrode might be dirty or positioned too close to the flame; check its position and clean it. Alternatively, the ionization electrode cable might be defective, requiring repair or replacement. Finally, a bad feed from the control box could be the cause, in which case you should replace the control box. If the problem persists, perform checks for flame default.
C
Christopher ParksAug 27, 2025
Why is the flame not of good quality in my SYSTEL SunPower 65?
- R
  Rachel SmithAug 27, 2025
  If the flame quality of your SYSTEL Gas Heater is poor, indicated by a red or black flame, it could be due to incorrect gas pressure. Ensure the gas pressure is around 37 mbar by using at least 4 bottles, checking the pressure on the gas regulator, cleaning the filter, and changing the gas regulator if needed. If the gas pressure is not between 18 and 21 mbar, check the pressure on the gas regulator and change the gas valve. Additionally, ignition or burner nose fouling could be the cause, requiring cleaning or replacement. Lastly, the type of gas might be the issue, so try using gas from a different supplier.
K
Kayla JohnsonNov 10, 2025
What to do if my SYSTEL Gas Heater has ignition issue?
- J
  Jared HodgeNov 11, 2025
  If your SYSTEL Gas Heater is experiencing ignition issues, here's what you can check: * Verify the fan is working correctly. * Ensure the overheat protector hasn't been triggered; if so, push it to reset. * Inspect and repair or replace any defective fan switch cords or overheat protector cables. * If the issue persists, the ignition feed or control box feed might be faulty, requiring replacement of the ignition or checking/replacing the transformer and fuse on the control box. * Also, ensure the gas entry is open and that there's no issue with the electrical feed to the gas valve by checking and repairing/replacing the cable between the control box and the gas valve. Finally, verify the gas pressure is adequate (around 37mbar, using at least 4 bottles) and regulate it on the ga...